English
简体中文Installing a storage shelf starts with buying a storage shelf.
The advantage of buying online is that you don’t have to work hard to go shopping in the furniture market. If you can go to one place or two or three places, it is difficult to have the time and energy to go to more places. Online shopping can complete multiple comparisons in a short period of time, and it is very accurate, all in the format you want to buy-the push of big data will be actively pushed to you.
Although the courier I encountered this time was very irresponsible, I refused to wait ten minutes for such a large and heavy shelf to get home, and put it directly in front of a store 200 meters away from the community, and I was the owner of the store. Said to be lost regardless of the circumstances. I arrived in ten minutes, but it was too large and heavy and could not be transported anyway. I had to unpack on the spot, take away the parts one by one, and go upstairs.
As a result, a pile of iron and wood components and a bag of screws wrapped in foam boards that were carried upstairs with difficulty became all the objects of assembly.
There is no manual, and there is no hint like assembly guide, which means: This is to say, who can't! It is self-evident that the individual will. Assembling games and juggling toy games that were played when they were young or, to be precise, their children played when they were young, can now come in handy. In all human labor, almost all the fruits of labor have been completed by people in this way. You only need to continue their initial conception of the design, and the process of combining all the fruits of labor is the last process. It should be the easiest process.
Indeed, there must be two main frames on both sides that look like iron ladders, with a horizontal board in the middle, and a horizontal beam needs to be installed under the horizontal board as a support for the horizontal board. There are also crossed iron bars on the back as a stretcher. All these installations require screws, and the type and usage of the screws are up to you to judge by yourself. The length and thickness and the bolts and nuts are matched with each other, and the correct choice must be obtained based on experience and on-site comparison.
As for the balance problem, symmetry problem, and the consistency problem of the tightening degree of the opposite screws during the installation process, we must always pay attention to it, otherwise the entire shelf will fall, tilt, or become incorrect. In the installation process, both hands are required to directly press and turn the screws regardless of friction, and considerable arm strength is also required to maintain the basic stability between the various accessories in a scattered state. The seller of the screwdriver gave a gift. In the case of special strength, one is not enough. You must have one in both hands to control the screw from two directions, and prevent it from rotating with the nut to achieve tightening. Effect.
In this way, the skin on the fingers has a rough and numb feeling due to the complicated strangulation, which is obviously a symptom of superficial injury; the muscles all over the body also seem to be involved in an exercise that requires full dedication and unknowingly. Fatigue between. As for the installation process, although there are some twists and turns, it is basically smooth. It's just that there is a problem with the installation of the four cross-stable iron bars at the back. In the end, the screws are not enough. Did you give them less? I made a judgment, no. It is used for the two iron bars installed in the front. There is no other way. I have to remove them one by one. Only one bolt and nut can be used in a group.
This assembly process has now been described in a high degree. The actual exploration, experimentation, and error correction process are very long, and the work of repeatedly screwing the screws with both hands is not easy. Because you are not a skilled worker, everything needs you to test it out. When you gradually gain insight and know how to do it more effortlessly, the work has been completed.
Because I was fully engaged, I didn't realize that a long time had passed until after I was finished, the night outside had fallen, and I didn't feel the tiredness all over my body. But now the time and physical effort are nothing. Now the main thing that is full of body and mind is pleasure.
This is a common phenomenon of doing this kind of special housework. The consequence is that after the excitement of installing it, I am eager to try and want to install another one. Even to see who still needs to install it, volunteered to install it. Nothing else, just to show your meeting, just to let the experience you finally get is not wasted in vain.
This, of course, has seriously violated another rule I summarized in my recent manual labor: working all the time is very hard. If you don’t do the work for a while, you will rest and do it tomorrow, or even a few days later. Work, the work is no longer so hard.
